Hydropolomb is a strong composition to moisture, which quickly hardens, while, including under the pressure of water. It is the brief set of grasping that is its main advantage. Largely due to the presence in its composition of fast -hardening cements, the composition, as a rule, sets it already after 1 minute, forming a cork that is not blurred by water.
What is the hydraulic fiber for? Basically, to eliminate accidents, the elimination of leaks that occur in stone and concrete systems, in areas of joints of blocks of the base of the house, well concrete rings, in basements, tunnels, in reservoirs. In addition, the composition has the opportunity to be used to stop water in water supply communications. The hydropolitan is ideal for use in emergency situations – in cases where the speed of setting materials directly affects how quickly the leak is stopped, which, in turn, determines the scale of the harm caused.
It should be noted that the use of hydraulics still belongs to the category of the last measures. Therefore, for this, in order to use it as little as possible, you need to pay special attention to the quality of waterproofing of different structures that are subject to water. This acquires a special meaning in cases where in the personal plot the level of groundwater is quite high, or, for example, the walls in the basements begin to proceed during the period when snow melts. It is important to keep in mind that timely and correctly performed work helps to avoid a lot of problems associated with increasing moisture in the room. In general, just in case, the hydraulic fiber still makes sense to keep on the farm. It will need, for example, to destroy the consequences of the breakthrough of the pipe in the basement.
It is very simple to make a hydraulic fiber. A small amount of special mixture will need to be sprinkled into a rubber or in a plastic container, after which it will be necessary to evenly add water to the container.
The composition can be mixed manually, but in the process it is necessary to use gloves, or special tools. In the process of setting the material, which is easy to determine by the active release of heat and by changing its density. The composition is completely hardened after a couple of min., But in many ways, the hardening rate is depending on the air temperature, the base, on the temperature of the prepared composition and the leakage used to block. The speed of hardening is regulated – for this, the temperature of the material and water should be changed. In conditions of low temperature, the material sets a little slower, and in high temperature conditions – on the contrary, a little faster.
The plane on which the hydraulic is planned to be applied should be thoroughly cleaned of dust, pollution. You will still need to remove insufficiently strong parts of the surface. Then you need to take the composition in a small amount, and apply it to the deformed area, in the process of pressing it with the hand, holding it until the end of the set. Impressive and complex defects are recommended to be treated a few steps. If the hydraulic fiber is used for suspension of leaks in the basement, then at first it should be installed in a hole that is suitable for the volume of water to drain water into a special container, and only after that can waterproofing, using the coating mass prepared on the basis of the cement.